Gorenje BO87ORAB Instruction Manual Page 17

  • Download
  • Add to my manuals
  • Print
  • Page
    / 44
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 16
243912
Memory programs (J)
The oven enables you to save three customized cooking modes.
Factory settings are already stored in memory programs (M1, M2,
M3); however, these can be changed by the following procedure:
- press the selected memory program once to display the
current (factory) settings (heater combination / operation mode,
temperature, cooking time).
- If you wish to change the settings, touch the selected memory
program (J); it will start ashing, and the settings can be
changed as desired.
- Con rm the settings by touching the selected memory program
key again.
- When you wish to load the stored settings, simply touch the
corresponding memory program key and start the cooking
process by pressing the (C) “start/stop” key.
- Any memory program can be replaced by new settings at any
time by pressing the relevant memory program key once again.
Oven thermostat control lamp (I1)
The control lamp is on; temperature in the oven is lower than
the set temperature, the heaters are activated.
When the set temperature has been reached, the control lamp
goes off and a short beep will sound.
During cooking, the heaters are activated and deactivated as
required; as a result, the control lamp goes on and off several
times as well.
When the symbol I2 is lit, the oven is still heating up; when the
set temperature is reached, the symbol goes off and it does not
reappear during the cooking process.
Sensor safety lock
Use this function to prevent any unwanted operation of the oven
(e.g. as a child lock).
Activate the function by pressing the (B) sensor key and
holding it for three seconds.
All sensors will be locked, except for the appliance on/off
sensor (A) and the safety lock sensor (B).
If any other sensor is pressed, a beep will sound, and the key
symbol (B) will ash quickly.
The safety lock is deactivated by pressing and holding the (B)
key again.
17
Page view 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 43 44

Comments to this Manuals

No comments