239839
feature, you may add washing detergent directly into the drum,
using the measuring vessel.
When adding softener, be careful to fi ll the dispenser
only up to the marked level.
Be sure to close the detergent dispenser when
opening/closing the appliance door.
• Push the START button (F). Sound signal confi rms the start,
the LED indicating particular washing stages stops fl ashing.
The machine starts operating after a few seconds. If the door
is not properly closed after starting the operation, the washing
stage indicator LED starts fl ashing again after a few seconds.
When you close the door, the machine initiates the selected
program.
• As each washing stage is completed the relevant washing
stage indicator LED goes off and the subsequent one goes on.
• In case you would like to alter the washing program after the
initiated washing operation, turn the program selector for one
second to the position “0”, followed by the selection of a new
program. Switching the machine off deletes any previously
selected additional functions(i.e. Pump stop), so they have to
be reactivated.
Upon switching OFF, all additional pre-selected
functions are deleted; therefore they must be switched-
ON again.
- End of washing program
The end of washing program is signalized by fl ashing washing
progress LEDs. The message “End” is indicated on the display.
• A sound is emitted, indicating that washing machine door can
be opened.
• Take the laundry out of the drum and remove any remaining
particles or foreign bodies from the door seal.
• Leave the door ajar to let the machine dry.
• Close the water inlet tap.
• Turn off the washing machine by rotating the program selector
knob (A) to position “0”.
• After the end of washing program, power supply should be
turned off by pulling the mains cord plug out of the outlet.
Start the operationStart the operation
14
Comments to this Manuals