Gorenje RF60309OX Troubleshooting Guide Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 24
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
149809
Required tools: socket spanner nr. 8, screwdriver, torx 25.
Caution! After unscrewing of before xing hinges, hold the door
to prevent it from falling and damaging.
1. Remove upper hinge cover (save it for eventual later use),
remove also the cover on the opposite side of the upper hinge
cover (on the opposite side you will insert the attached cover
during the assembly), and remove the cover on the opposite
side of the upper part of the door.
2. Unscrew upper hinge screws and remove the upper door from
the middle hinge.
3.On the bottom side of the upper door unscrew the swing
stopper screws and remove the stopper (A). Keep this for
eventual use later on. Fix the attached stopper with its
bearing on the opposite side of the door.
4. Unscrew the forced door closure system (B) and x it to the
opposite side of the door (certain models only).
5. Unscrew middle hinge screws, remove the door from bottom
hinge.
6. Unscrew leg holder xing screws.
7. Tilt the appliance backward (max. 35°) to lean to the rear
side of the cabinet. Unscrew the leg support screws (C) - left
and right, and remove the leg support cover (D) and place it
to the opposite side. Unscrew and remove, then reciprocally
replace the position of end switch (E) and decorative peg (F)
(for models with forced door closing system). Unscrew three
screws xing the bottom hinge (save the hinge for later use),
and x the attached bottom hinge on the opposite side.
8. Repeat the procedure 3 and 4 on the bottom door. In case
there is no bottom door limit peg, transfer the bearing (G) and
washer to the opposite side of the door.
9. Proceed with the assembly procedure in opposite sequence.
Note:
In appliances with the handle along the entire height of the door,
the reverse door swing is not possible.
Remark:
At OLD TIMER appliances (in the model marking …O…)
alteration of door opening direction is not possible.
10
Reverse door swing
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Comments to this Manuals

No comments